Bed Frame Queen Platform
First off, you flip out the first part of the section Bed Frame Queen Platform (theres two identical sections) flat on the floor and open the legs at each end. There are two support beams that open out with little hooks at the ends. You will see the two little wingnuts that obiviously have to be adjusted to slide the hooks under the nuts then tighten the wingnuts down nice and snug. Do this for the next three legs of the section.
Bed Frame Queen Platform
Second, once you achieve this, make sure that you have enough tightness by testing the beams by jiggling them to check for any movement. If theres none, then you're good. If there is, flip back over and retighten. Recheck and move to the next piece.
Bed Frame Queen Platform
Third and Last, once you have the second section the same way, bring them right next to each other and attach them using the two long screws in the little bag provided in the box. The black rubber part is to be placed between the two frames Bed Frame Queen Platform (unscrew the wingnuts on the ends of these screws and run the plain long screw through the end of the first section, place black piece on the end of the screw before going through the other side and slide over). Grip the frame tight together and use the last little wingnut to screw snugly at the end. Do this for the other end and you got it.
Bed Frame Queen Platform
